scottyrs

iTrader: (1)

as above need some welding done on my floor pan and boot asap as i missed my slot at the garage as my car wouldnt start now it cant be fitted back in and my mot is due! cheers ideally need it done before xmas

dingla rs

iTrader: (2)

id do it if you were bit neara pal ,don't you have any mates that weld ?

scottyrs

iTrader: (1)

no mate dont know any welders getting very p***sd off now might just get rid

as355f1

Bell me the moz on 0191 2683659 i will try and fit u in

scottyrs

iTrader: (1)

where are you at mate? and any idea on a price if i show you some pics of what need done

dingla rs

iTrader: (2)

id gladly do it if you could leave it and ur stuck but i am 40miles away pal sure some one neara come throw

Cossy Mike

iTrader: (4)

Easy to think like this mate, I been there.

Chin up, will come good in the end....

Which garage did you miss your slot??

scottyrs

iTrader: (1)

seymours in new harley was introduced to it by a mate but when i went to take the car itr wouldnt start thats was nearly 2 weeks ago only got it going last nite!

as355f1

westmoor mate next to killingworth, stick some pics up and i will give u a rough quote

scottyrs

iTrader: (1)

havent got boot pic but its in the spare wheel well and about 50p size hole pm a price if you wish bud i work in the north tyne ind estate so very close to kily

scottyrs

iTrader: (1)

isnt that bad to be honest but obviously fail mot with the hole and its only going to keep getting worse!

as355f1

if the carpets are out and you just want some plates welded over the holed bits to get it through its test then approx Ł80 looking at the pics, if you want a pukka job doing i will need to see it and it will be lots more.

scottyrs

iTrader: (1)

its totally stripped only thing in is my seat and rear bench mate its all ready to go basically wanted the rot cut out and a plate but in really if thats the best way to do it dont want it comming back

as355f1

let me see it the morra mate, bell me in the morn

gtinutter

i at houghton matev just did the same welding to dave sierra from north shield cost about 80 mate to do using good plate and all undersealed after

scottyrs

iTrader: (1)

ok mate cheers you have pm