where have you put yours? get your pics up. thinking of modding my gear knob but need some different ideas

 

pics of a switch

 

If you add a wheel speed sensor to it then you can have launch control permantly on as it will only work below a certain road speed, You can also add a switch also to this to turn off, or have a button that you press and hold for launch.

Mark

 

replaced the horn on the sterring wheel with mine

 

brilliant ive used a sensor of an xr2i 16v that goes on the speedo cable. tested it this morning whenb i powered up ecu testing everything and works spot on so that answeres that! well impressed with the autronic btw! thanks!

 

If its hall effect then it can be wired in no problems, Use HSI3 for the road speed input.

Mark

 

yep done that already just have to play with the wheel revolutions to get it right.one less thing to worry about then. il just use a switch for on/off

Batt Voltage Dwell time
8 Volt 7 ms
10Volt 5.5 ms
12 Volt 4.5 ms
14 Volt 4.0 ms
16 Volt 3.0 ms

does that sound right to you for coils? got it off a guy on the bba remon site he said that should be fine?

 

my dad's launch control button is next to the handbrake and linked to the handbrake

so once you put the handbrake down it goes

 

Put mine on the steering wheel.

 

You realy need the manufactors settings for them as coilscan vary a Skyline only runs 1.8ms at 14v.

Mark

 

mate dunno if you can see the red button on mine mark fitted mine up with it and i mounted it there, can be reached perfect when in first gear!!!

 

that looks good cheers! on the loom ive made i was going to use the launch button as hold to set but now marks said i can use the speed sensor (which i should of realised) i will just use it as on/off the same as the nos and water injection etc. easier i think. looks good there tho!! take it your running autronic or similar? really seems to be a good bit of kit! and very user friendly!!

 

got the sparco steering wheel mounted push buttons for mine, one is going to be for launch control other for nos or co2 spray onto intercooler (i know co2 getting into inlet isnt great as well before anyone says that)

 

i know befofe the arguements start lol. dont think it matters too much on idle at pod on a red hot day if a bits sucked in! if i dont sort my charge cooler setup il be using it for sure!! do you know anyone thats used the spray bar before?? temp differences/how long etc? something id like to look into as i want to do 1/4 mile mainly