PassionFord - Ford Focus, Escort & RS Forum Discussion
0 2018/04/15 05:18:07
0 2018/04/15 05:17:59
Not keen on the sculpted side panels. Carbon Kevlar door is on the right side of this pic.
Not keen on the sculpted side panels. Carbon Kevlar door is on the right side of this pic.
0 2018/04/15 05:15:00
0 2018/04/15 05:14:51
0 2018/04/15 05:14:43
Trial fitted the carbon roof spoiler to my grey gti, it will go higher when I remove the little spoiler, obviously this would be for the red car. I have a big t16 spoiler on the way to compare.
Trial fitted the carbon roof spoiler to my grey gti, it will go higher when I remove the little spoiler, obviously this would be for the red car. I have a big t16 spoiler on the way to compare.
0 2018/04/15 05:14:34
Went to Howletts zoo, the keepers whizz around on these old milk floats, the whirring sound took me back a bit.
Went to Howletts zoo, the keepers whizz around on these old milk floats, the whirring sound took me back a bit.
0 2018/04/15 05:14:25
0 2018/04/15 05:14:12
0 2018/04/07 07:32:13
0 2018/04/07 07:32:00
Few more pics
Few more pics
0 2018/04/07 07:31:48
0 2018/04/07 06:46:11
0 2018/04/07 06:45:56
I like this one
I like this one
0 2018/04/07 06:45:44
There seem to be two like these
There seem to be two like these
0 2018/04/07 06:45:31
Crane that I mentioned
Crane that I mentioned
0 2018/04/07 06:45:16
0 2018/04/07 06:13:40
All are a bit dusty but complete
All are a bit dusty but complete
0 2018/04/07 06:12:41
There’s also a big unimog and some other powered off roaders
There’s also a big unimog and some other powered off roaders
0 2018/04/07 06:11:50
0 2018/04/07 06:11:14
I will do some more pics but just pick anyone and I will box it, they all have boxes and instructions
I will do some more pics but just pick anyone and I will box it, they all have boxes and instructions
0 2018/04/07 06:10:34
0 2018/04/07 06:09:56
0 2018/04/07 06:09:26
Hi, Kev I finally got round to doing some pics. I also found a few still in boxes, there is a massive crane still boxed and I think they are over £100
Hi, Kev I finally got round to doing some pics. I also found a few still in boxes, there is a massive crane still boxed and I think they are over £100
0 2018/04/07 06:08:45
Here is a pic of the billet floor mounted pedal box, I am going to try the car without servo again as this is a better version. We have explored remote servos but prefer not to if we can get the feel right.
Here is a pic of the billet floor mounted pedal box, I am going to try the car without servo again as this is a better version. We have explored remote servos but prefer not to if we can get the feel right.
0 2018/04/06 06:16:18
0 2018/04/06 06:16:16
Mark has cut out all of the stuff he didn’t like ready to put in all new. The old setup had the exhaust swap sides on the car by humping over the gearbox bellhousing, this always gave ride height issues as at 3.5 inch diameter plus some air gap over the box it needed a lot of room, I have asked Mark to send the pipe straight up the car by raising the floor a bit as it then doesn’t need to cross the gearbox and it will jump over the cradle if needed as I don’t mind the boot floor being amended.
Mark has cut out all of the stuff he didn’t like ready to put in all new. The old setup had the exhaust swap sides on the car by humping over the gearbox bellhousing, this always gave ride height issues as at 3.5 inch diameter plus some air gap over the box it needed a lot of room, I have asked Mark to send the pipe straight up the car by raising the floor a bit as it then doesn’t need to cross the gearbox and it will jump over the cradle if needed as I don’t mind the boot floor being amended.
0 2018/04/06 06:16:12
This was on a Mickey Mouse intercooler so Mark had to hold it back, it was also on a standard inlet. My cooling system was pressurising and he thought it might have been head lift...turned out to be fault pressure cap on expansion tank (sounds like racing driver excuses but all adds up) this was on the bog standard 2.0.
This was on a Mickey Mouse intercooler so Mark had to hold it back, it was also on a standard inlet. My cooling system was pressurising and he thought it might have been head lift...turned out to be fault pressure cap on expansion tank (sounds like racing driver excuses but all adds up) this was on the bog standard 2.0.
0 2018/04/04 10:38:23
This allows fuel in to the sump "can"
This allows fuel in to the sump "can"
0 2018/04/03 14:07:00
Bad pic but allows the fuel in to the "can"
Bad pic but allows the fuel in to the "can"
0 2018/04/03 14:06:03
0 2018/04/03 14:04:48
0 2018/04/03 14:04:46
0 2018/04/03 14:04:45
Tapped it for m10 and threadlocked in a titanium bolt.
Tapped it for m10 and threadlocked in a titanium bolt.
0 2018/03/30 05:02:11
Oil seal with grove for the pin
Oil seal with grove for the pin
0 2018/03/30 05:02:03
It has always annoyed me that when working near the sump I would always scratch my arm where someone had just cut off the unused speedo cable and left strands, the plastic gear just spun in the housing so today I made a plug / bung on the lathe.
It has always annoyed me that when working near the sump I would always scratch my arm where someone had just cut off the unused speedo cable and left strands, the plastic gear just spun in the housing so today I made a plug / bung on the lathe.
0 2018/03/30 05:01:54
I forgot I had these, I found them when clearing out the loft on my workshop today so will see if they will go on the front or rear of the car. I am having a latching handbrake so will not need a cable.
I forgot I had these, I found them when clearing out the loft on my workshop today so will see if they will go on the front or rear of the car. I am having a latching handbrake so will not need a cable.
0 2018/03/30 05:01:45
Cage and floor going in next week
Cage and floor going in next week
0 2018/03/29 08:56:55
0 2018/03/29 08:56:54
Obviously the top mounts will not be that high
Obviously the top mounts will not be that high
0 2018/03/29 08:56:52