Caddyshack
April 6, 2018
Mark has cut out all of the stuff he didn’t like ready to put in all new. The old setup had the exhaust swap sides on the car by humping over the gearbox bellhousing, this always gave ride height issues as at 3.5 inch diameter plus some air gap over the box it needed a lot of room, I have asked Mark to send the pipe straight up the car by raising the floor a bit as it then doesn’t need to cross the gearbox and it will jump over the cradle if needed as I don’t mind the boot floor being amended.
Original Thread
Peugeot 205 with 4wd cosworth engine and running gear.More About This Picture
Vehicle
N/A
Location
N/A
Keywords
N/A
Discover More Pictures
See MoreAdvertisement
Be the first to comment on this picture!