hey just wanting to no how the bearing housing cos apart from the exhaust housing.??rhanks>evan

 

anybody have any idea??need to replace oil seals>evan

 

5 nuts on the compressor housing iirc, but you will need to get it ballanced again after a rebuild or it will morethan likly distroy itself after a while

 

the answer to the question is lots of hard taps around the core to split it from the exhaust housing. don't go too much on one side as it could damage the exhaust turbine blades.
as said though it may need balancing, just mark the nut/shaft and wheel with a scribe and it should be fine when put back together, maybe the tiniest bit out of balance.

 

it is sitting loose an i can turn the bearing houseing but it just wont pull apart from the exhuast houseing??>evan