Hi can any one tell me what crank sensor i need to use on a zetec block when running fiesta turbo managment please.

cheers,
Phil

 

what flywheel did you use??

 

Whichever one you can get to line up best with the proper gap.
tabetha

 

was gonna use the frst one.

 

then use the fiesta sensor then mate thats what i did on mine and its fine

 

blindin' thanks for that mate much appreciated.

Cheers,
Phil

 

on a 2litre zetec can u just bolt fiesta rs turbo inlet manifold on then?with no mods?

 

no you need an adaptor plate

 

you'll need to plates one to allow you to bolt it to the head and the other is a spacer plate that goes inbetween the two halves of the inlet to raise it up by 13mm so that the throttle body can clear the zetec cam cover.

 

Has anyone else done this in KENT, im thinking of putting one in a kitcar.

 

done what the zetec turbo conversion?

 

yes,
I would prefer to see one in situ so I can gauge the issues in fitting it to a caterham type car.

Currently got a zetec 1.8 on carbs.

 

im prity sure ive seen a wastfield with a zt

 

there is a guy on here who has a high spec zt engine a yellow caterham not sure of his name i'll have a look through some old posts to see if i can find out.

cheers,
Phil

 

im getting a 1.8 zetec engine for my frst or maybe the 2.0 but does anyone no what the best series to go for is for both these engines? and is the easiest to work with turbo and fit ect?

 

There's no replacement for displacement!

 

In this case listen to a womans advice (but only this time)......Bigger is better!