Sump plug..
#1
Ben
Thread Starter
Sump plug..
The bright spark who owned my car before me managed to round the cunting thing off!!!
Going to have to weld a bar to it to get it off!
Where's the best place to get a replacement Plug + seal?
Thanks
Ben.
Going to have to weld a bar to it to get it off!
Where's the best place to get a replacement Plug + seal?
Thanks
Ben.
#4
Ben
Thread Starter
I did think about treating myself to some magnetic ones..
And it's a little 1.25 Fezza.
Ben.
And it's a little 1.25 Fezza.
Ben.
#6
I've found that life I needed.. It's HERE!!
mushroom the end with a big hammer then just chap on a single hex socket
should come off ok, most motor factors will stock old ford 1's,
good thing is the old fords all had the same sump plug fitted so be easy to get 1 quite cheap(couple quid)
should come off ok, most motor factors will stock old ford 1's,
good thing is the old fords all had the same sump plug fitted so be easy to get 1 quite cheap(couple quid)
#7
Testing the future
how badly mangled? if it's an an external hex, before you try anything, get some irwins on it:
http://www.amazon.co.uk/Irwin-Bolt-G.../dp/B0000CCXVZ
available other places, that was just the first link i came to
http://www.amazon.co.uk/Irwin-Bolt-G.../dp/B0000CCXVZ
available other places, that was just the first link i came to
Trending Topics
#9
Ben
Thread Starter
Thanks for the help guys, my mate has lent me his Irwin set so i'll give them a whirl first, if not i'll give some of your tips a go.
Thanks
Ben.
Thanks
Ben.
Thread
Thread Starter
Forum
Replies
Last Post