tezmanian devil

iTrader: (8)

the time has come, i'v had enough and i need to fund my gas course so i can work for myself finaly

there's lot's of nice bit's on the car so have a good read through, i dont really want to start breaking the car until the engine and shell have sold, but if i get enough name's down for everything else i will just start breaking it.

all price's do NOT include postage as i would rather people come and collect in person from eastbourne, that way you can see the part your buying befour any money change's hand's...
however, i will put a postage price next to the item's i can post.
i am open to sensible offer's on everything, but i wont let thing's go for peanut's so please, no stupid offer's...

there's picture's of most part's in my project thread here:
https://passionford.com/forum/restor...7-02-11-a.html
i'l post some pic's at the bottom of this for sale thread aswel.

anyway here goes...


xr3i 130/rs2000 MTX-75 gear box, fitted is a ford torsen LSD and the gear ratio's have been played with in order to atcheive 180MPH (was fitted to 'christian&beckys' old s2) £750 colection only or arrange your own courier.

rover m16 inlet manifold (this is the bigger rarer one) modified to allow fitment of a cosworth throttle body, cosworth green injector's, adaptor plate to fit to zetec head, fuel rail £350 + £16 p&p

TTV racing flywheel, to suit rst or zetec, hardly used when fitted to christian&becky's s2 £100 + £10 p&p

alloy oil breather/seperater with little breather filter £60 + £5 p&p

sard feul pressure regulater, -6 fitment £125 + £5 p&p

feulab feul filter -6 fitment (black) £100

front mount intercooler measure's 600mm long by 300mm tall, universal style fitment, brand new, fitted but never used. £100 + £17.50 p&p

s/s exhaust downpipe, heat wrapped, this is made to fit my car so may need altering to fit other's? £30 + £8 p&p

ford racing boost and oil pressure gauge's £60 each + £5 p&p for each

rs2000 rear disc beam powder coated blue with yellow anti-roll bar, fully poly bushed, no disc's, hub's etc as already sold £35

rs2000 front subframe powder coated blue with yellow anti-roll-bar, arb is poly bushed aswel. £80 colection only or arrange your own courier

325mm gold HI-SPEC's, brand new, fitted but unused, slight surface rust on disc's from being sat around on the car £850 + £26 p&p

GAZ gold coilover's, fully height and damping adjustable, virtually new, only been used for a couple of hundred mile's £350 + £20 p&p

front e-tech strut brace to suit mk6 strut top's £50 + £5 p&p

rear sparco strut brace, was mk5, but also drilled to suit mk6, powder coated black. £50 + £5 p&p


one off rs2000 buldge/bubble bonnet, the bonnet has been cut and a scoop/vent formed into it, no stick on crap, done properly! £120 collection only!

aero catch lockable bonnet pin's, brand new and still in packaging £35 posted

mk5 rs/xr morrette head lamp's, inner lamp have been removed and air duct's put in there place, will come with all wireing £200 + £12 p&p


escort cosworth HEX cloth interior, front + rear seat and front + rear door card's, good condition, but need a clean, 1 rear card is broken, but back seat cover's it... £350 collection only!


mk5 steering wheel boss £20 + £5 p&p

17x8 compomotive MO's et35 iirc will have to double check, but i think the tyre's size's are as follow's.... 2x 215/45/17's and 2x 205/40/17's, all tyre's are toyo t1r's and all have plenty of tread because i only used them for 3 month's on my old saph, all wheel's are mint! and havnt seen a road since being powder coated black!! come with blue centre's £600 collection only.

DTM wing mirror's to suit mk5/6 escort, brand new, only trial fitted a couple of week's ago £20 + £5 p&p

WRC fibre glass grill, brand new, but been chopped down abit so it would fit above the front bumper properly, still look's the part though, no mesh fitted, £35 + £6.50 p&p



there's plenty more that's i'v proberly forgoten, but once i start to break the car i will update with pic's and price's etc.

i would prefer collection on all the above idealy because i find it hard to get time to go to the post office to post thing's, so you may have to bare with me if your wanting something posted, i will do my best to post thing's as quick as i can though!!


here's a few pic's of the car and a few part's, i can get pic's of individual part's on request if need be....
















there you have it, i really am gutted to be doing this, but i really need to sort my life out and get my career sorted, if i could afford to do my gas course aswel as get this finished i would, but unfortunetly i cant atm so need's must, only a car at the end of the day eh

like i said above, all price's are ONO so sensible! offer's are welcome.

thanx for looking.

scoobypete

could i please have a pick of the -6 aroquip please thanx

tezmanian devil

iTrader: (8)

few more pic's for ya mate

scoobypete

will you sell just fittings please mate? £30 posted

tezmanian devil

iTrader: (8)

sorry, want to sell as they are, the braided line's are no good to me without the fitting's...

£45 posted and there your's, i'l even throw in 2 brand new stright fitting's i have in my tool box that never got used oh and i have to adaptor's that you can use to convert from normal feul line's to aeroquip, il throw these in aswel as they'l be no use to me either

tezmanian devil

iTrader: (8)

MSD coil pack and lead prov sold
-6 black aeroquip fitting and hose prov sold

muz

I really shouldn't be doing this, but whats the shell like? Obviously needs paint, but are they fibre glass panels etc, full front wings or just the half jobs?

oriurbo

Shame you have to break it mate.
What is the turbo like any smoke etc i presume it is a garret turbo.
Also whats the best price you can do on the turbo thanks.

grant_xr

Whats the ford torsen diff out of mate?

Grant

tezmanian devil

iTrader: (8)

the shell's spot on mate, very clean, no rot anywhere, i stripped the underside and re under sealed it all befour ftting anything back on, there's brand new hand brake cable to suit rear disc beam, new copper brake line's run through, and will come with...

rear bumper
all glass
mk5 dash complete minus cossie banana pod
interior loom
carpet
rear boot panel's etc
rs2000 master cylinder and servo
feul tank minus sender unit
mk5 rs2000 recaro interior

all the panels are the proper cosworth rep jobby's, full front wing replacment's (wheel's sit nicely in the middle unlike some) rear quarter wing's are the complete one's aswel that sit upto the rear lower spoiler, and obviously side skirt's and rear bumper are also fibre glass.
the shel does require painting unfortunetly because i began rubbing itback, plus a few chip's and scratch's from being stored in a active workshop...

i can sell it rolling with the powder coated subframe and rear beam etc of eith the gaz gold coilover's or on standard shock's but a price would need to be discussed for that.

shell is a P reg btw

yeh it's a garret, no smoke, and VERY little play in shaft, no actuator, but will come with braided oil feed, and the return pipe with abit of blue samco
very reluctant to lower my price for the turbo to be honest, i paid £320 for it and havnt actually used it seem to have quite abit of interest on it aswel...

no idea mate, cant remember if im honest, 'christian&becky should know.

muz

Very interested in the shell actually for a future project. I would need it as cheap as possible so I'll message you when I've had a look at my storage arrangements and cash flow tomorrow. Have you got any other pics you could send to Eversham@hotmail.co.uk just it's a long way to come to view! Lol. Just things like the inner arches where they meet the fibre panels etc

-beefy-

iTrader: (6)

all the fuel lines gone fella ?

do they run front to back ,


few choice bits there i wouldnt mind for the s1 - just need the pennies together lol

tezmanian devil

iTrader: (8)

i dont think i have any pic's like that tbh, i can get some saturday for ya though, il pm you when i have some and we can discuss further if you do want it, if i had somewhere to hide it i'd hold onto it because it is very solid!

all the one's worth having have provisionly mate, i do have normal braided line's but not sure if there any good to be honest.
thing's alway come up when fund's are no good i can relate to that lol

muz

Yes mate if you could just so I can see it before I come down but I'll have first refusal on it.

tezmanian devil

iTrader: (8)

not a problem atall mate

tezmanian devil

iTrader: (8)

bump

iv started stripping the car so everything can go whenever :top

tezmanian devil

iTrader: (8)

shell prov sold

tezmanian devil

iTrader: (8)

all pm's replied to...

here's a few more pic's of some part's...


samco coolant hose kit for zetec (escort mk5/6)


alloy clutch pedle quadrant


HI-SPEC 325mm front brake setup and 17" comp mo's



oil breather/seperater


il be pulling bit's off the car tomorrow so will upload better pic's of part's etc when im back home

tezmanian devil

iTrader: (8)

right, i keep having people saying they will have and pay for thing's by a certain date but not coming through with payment's, so everything's now on a first come first served basis, whoever's got the cash first get's the part...

here's a few more pic's of part's...


[IMG]http://i102.photobucket.com/albums/m106/tezmanian_devil/for%20sale/cf322d20.jpg[/IMG






[IMG]http://i102.photobucket.com/albums/m106/tezmanian_devil/for%20sale/e680a1b8.jpg[/IMG






the focus rs clutch pressure plate bit has been ground down round the edge's so that it would fit into the mtx-75 rs2k gearbox, but this doesn't effect the clutch in any way, and still work's as it should.

feel free to pm me with any question's etc

isaac james sherwood

pm sent omex

McGoo 69

did you get my pm about the shell

i have cash waiting and im in desperate need of a new shell to finish my rep project as mines too rusty

cheers matty

tezmanian devil

iTrader: (8)

replied

sorry dude, thought i had replied, the shell's provisionly sold to muz pending collection when we're both available...
there's a couple of rep's on piston head's that could be used as a donor?

muz

Yeah, shell is coming to me. I'll pm you Tomoz with a collection date.

tezmanian devil

iTrader: (8)

cheers dude

omex, frs ap clutch, engine mount, track design's front mount alternator kit, rad fan's and esc cos intank pump sold

scoobypete

hiya mate, cash as promised, could you please p.m me pay pall details for aeroquip, and how much for oil cooler?

tezmanian devil

iTrader: (8)

need your address detail's bud...

oil cooler's sold im affraid mate.

tezmanian devil

iTrader: (8)

list now updated

tezmanian devil

iTrader: (8)

bump, list has been updated, need the last of this gone asap so we can have some space back

tezmanian devil

iTrader: (8)

some bit's now on ebay...

http://cgi.ebay.co.uk/ws/eBayISAPI.d...STRK:MESELX:IT

just check my other item's for other bit's, more will be added over the next few day's