Graham S1

My brother has asked me to sell his turbo for him, that was going to go on his Escos, but he sold it a few months ago.

GT35 hybrid, 360deg thrust bearing, polished housing, AR 0.63. It may have cutback blades, but he can't remeber, and not sure how you tell? Will take another closer photo of blades later.

Any ideas people?

alo

I think this is a t34/35 mate gt turbo's are roller bearing cored and I don't think I've seen a internally gated one yet.

£250/ £300 for a t34

allsteel

I'm on that thought also.I've never seen an internally gated GT35

RS SHAUN

iTrader: (24)

im looking for a t34 for my 2wd saph, if this will fit?

Graham S1

Fair enough, only going on what my brother remembers/told me. Not a turbo expert myself.

westus1

iTrader: (6)

defo looks like a t34.63
prices above are about right

if it was a internal gate gt35 it would be worth a forune
but the size of the compressor housing would be a lot bigger if it was a gt35

Graham S1

is this a lambda sensor?



and some more of the blades.







for any who enquired, I have to check with my brother who is 12 hours behind us at the moment, so responses will not be quick.

westus1

iTrader: (6)

yes thats a lambda sensor
blades look standard to me

TiB

iTrader: (1)

Rear blades are cut back.

usually done at 7 degrees but no guarentee these are.

westus1

iTrader: (6)

if these blades are cut back then maybe mine are as well
as i'm just going by comparing it to mine

the ones i've seen before were at a greater angle than that but i'm no expert