Lots of cossie Engine goodies and more!
21-03-2008, 01:00 AM
#1
10K+ Poster!!
Thread Starter
iTrader: (9)
Join Date: May 2004
Location: birmingham west mids
Posts: 11,919
Likes: 0
Received 11 Likes
on
9 Posts
Lots of cossie Engine goodies and more!
Due to a new project, I am selling a vast collection of my cossie parts I have aquired over the years 
.. I don't really want to sell any of it but it is a huge amount of cash to have tied up in spare parts, "just incase".
1) Cossie 200 block, WRC 6 Long studded, on a std Bore at the moment, very slight lip at the top, might hone might need a bore to 0.25, no damage at all to the bores, absolutly mint block, £900
2) Cossie 200 Block, WRC 6 Long studded, on a fresh 0.5 overbore, ready to go, and proffesionally painted in red engine laquer. £925
3) Set of arrow/ burton power H section forged Steel conrods, brand new, never used at all, std length. £600
4) J.E forged lightweight High compression pistons, 8.5:1, brand new with rings and pins, £600
5) Rouse sport rear spoiler in moonstone on a moonstone blue bootlid, has a few small dents but nothing major, comes with badges etc, the spoiler has a very small chip about the size of a 2p,and about 1-2mm deep on the rear right edge, and a few other tiny chips, would fix very very easy before painting, £250 complete.
6)WRC 8 injector manifold, inc fuel rail, fuel pressure reg, £400
7)P8 Super 8 ECU, with 8 injector driver board, anti-lag board, water injetor drivers etc, can come with brand new 8 injector sub loom, £500
8)Brand new genuine ford Sapphire Cosworth Front bumper, with towing eye cover and trim strip, not even in primer, absolutly brand new, £400.
9) 2wd cylinder head, will have to check the thickness as I cannot remember, but is mint, has been faced, pressure tested, ported & gasflowed to 25/26mm ports, all the valve guides replaced and shaped/cut away to aid airflow, ready to bolt on and run. £SOLD
10) 8x Rondell 122 17" wheels, 6 mint/vvv good condition, 1 has a kerb mark about 20-25mm long and about 2-3mm deep, and 1 has a flat spot from a pot hole, and does not hold air, looks like it will repair as there is no crack. All have good tyres on bar 2 or 3, would prefer to sell all 8 together, but could split for a good offer. £1200 the lot
11) 4x Brand new Toyo Proxes T1's, old model, 205/40/17's, never been on a wheel still have the delivery labels on, £200
12) 8x dark green 803 injectors , £120 a set of 4 or £215 for all 8.
13) Red magnacor 10mm silicon HT leads, brand new in box, £100
14) Brand new 2wd high pressure (75psi) oil pump, brand new in boxx, genuine cosworth £120
15) GT35 Rollerbearing turbo, came from Universal turbos, brand new in box, £930.
16) 2wd sump+ pick up pipe, all vgc, £50
17) set of 4x4 standard con rods, vgc, £100
.. I don't really want to sell any of it but it is a huge amount of cash to have tied up in spare parts, "just incase".1) Cossie 200 block, WRC 6 Long studded, on a std Bore at the moment, very slight lip at the top, might hone might need a bore to 0.25, no damage at all to the bores, absolutly mint block, £900
2) Cossie 200 Block, WRC 6 Long studded, on a fresh 0.5 overbore, ready to go, and proffesionally painted in red engine laquer. £925
3) Set of arrow/ burton power H section forged Steel conrods, brand new, never used at all, std length. £600
4) J.E forged lightweight High compression pistons, 8.5:1, brand new with rings and pins, £600
5) Rouse sport rear spoiler in moonstone on a moonstone blue bootlid, has a few small dents but nothing major, comes with badges etc, the spoiler has a very small chip about the size of a 2p,and about 1-2mm deep on the rear right edge, and a few other tiny chips, would fix very very easy before painting, £250 complete.
6)WRC 8 injector manifold, inc fuel rail, fuel pressure reg, £400
7)P8 Super 8 ECU, with 8 injector driver board, anti-lag board, water injetor drivers etc, can come with brand new 8 injector sub loom, £500
8)Brand new genuine ford Sapphire Cosworth Front bumper, with towing eye cover and trim strip, not even in primer, absolutly brand new, £400.
9) 2wd cylinder head, will have to check the thickness as I cannot remember, but is mint, has been faced, pressure tested, ported & gasflowed to 25/26mm ports, all the valve guides replaced and shaped/cut away to aid airflow, ready to bolt on and run. £SOLD
10) 8x Rondell 122 17" wheels, 6 mint/vvv good condition, 1 has a kerb mark about 20-25mm long and about 2-3mm deep, and 1 has a flat spot from a pot hole, and does not hold air, looks like it will repair as there is no crack. All have good tyres on bar 2 or 3, would prefer to sell all 8 together, but could split for a good offer. £1200 the lot
11) 4x Brand new Toyo Proxes T1's, old model, 205/40/17's, never been on a wheel still have the delivery labels on, £200
12) 8x dark green 803 injectors , £120 a set of 4 or £215 for all 8.
13) Red magnacor 10mm silicon HT leads, brand new in box, £100
14) Brand new 2wd high pressure (75psi) oil pump, brand new in boxx, genuine cosworth £120
15) GT35 Rollerbearing turbo, came from Universal turbos, brand new in box, £930.
16) 2wd sump+ pick up pipe, all vgc, £50
17) set of 4x4 standard con rods, vgc, £100
Last edited by RWD_cossie_wil; 22-03-2008 at 01:52 PM.
21-03-2008, 01:05 AM
#2
PassionFord Post Whore!!
iTrader: (4)
Hi mate, I'm interested in the front bumper. I assume it comes with the side mounts that always break lol. Do you have any pictures of it?
Last edited by Paul_RS; 21-03-2008 at 01:09 AM.
Trending Topics
22-03-2008, 02:12 PM
#14
10K+ Poster!!
Thread Starter
iTrader: (9)
Join Date: May 2004
Location: birmingham west mids
Posts: 11,919
Likes: 0
Received 11 Likes
on
9 Posts
Hi Guys, sorry I can't post pics as the stupid works filter wont allow access to photobucket or any other media centre 
.. If someoene wants to host the pics for me then give me an email link and I can send you the pics, same for anyone who wants pics of any other parts 
.. If someoene wants to host the pics for me then give me an email link and I can send you the pics, same for anyone who wants pics of any other parts
22-03-2008, 05:00 PM
#15
PassionFord Post Troll
24-03-2008, 02:03 AM
#20
10K+ Poster!!
Thread Starter
iTrader: (9)
Join Date: May 2004
Location: birmingham west mids
Posts: 11,919
Likes: 0
Received 11 Likes
on
9 Posts
Rouse spolier
There are a few other very small chips, but nothing mega and would take next to no time to prep before painting, and the boot lid has a few small dents, again nothing to worry about before a paint
There are a few other very small chips, but nothing mega and would take next to no time to prep before painting, and the boot lid has a few small dents, again nothing to worry about before a paint
andy your PM box is full
803
Thread
Thread Starter
Forum
Replies
Last Post
JoeyBoyden
Restorations, Rebuilds & Projects.
26
04-01-2024 02:36 PM
track.focus'd
Restorations, Rebuilds & Projects.
26
12-08-2015 05:53 PM
CabrioTurbo
General Car Related Discussion.
1
01-08-2015 11:04 AM