Has anyone information about the pin arrangements of RS1600i ignitonmodul...?
I have a modul, but I could not get cabel und original twin coil to it.

 

Ive got a diagram of the ignition system showing where the wires go from the pins if thats any help to you?


http://img.photobucket.com/albums/v4...16idiagram.jpg

The RS1600i has its own ignition wiring loom seperate from the main cars wiring loom which ran from the ignition module under the dash to the twin coils and sensor on the engine. You will need this loom if your planning to run thr 1.6i setup

 

Hi,

could you tell me, whether the 12V is on the pin 4? Or on the pin 3?
It is missunderstandable according to diagram.

 

Nobody? Nothing?

 

hello there

Give me a couple of days, i will check the pin wiring locations on my own RSi and then i will get back to you

 

THX 1000x!

 

12V is on Pin 4.

 

Thank you very much!

 

Next question from Geree, typing by me

Where is the crank sensor located of the RS1600i?
As we found, there are no marks on the backside of the flywheel as for example on the EFI engines. I read somewhere, that there was some magnetic sign. Could you please explain it to us?

If we can't get original parts to it, is it possible to use a crank trigger kit with a 36-1 wheel, such as BurtonPower is selling?

Thanks!

 

Theres supposed to be some sort of 'magnetic tooth' on the RS1600i flywheel that triggers the sensor, which is positioned in a specially machined hole on the underside of the bell housing on the RSi box. to be honest ive never seen it on my own flywheel

Its supposed to run over the sensor and trigger the sensor, which in turn sends signals to the ECU to indicate the engine speed

im not sure whether the crank trigger kit would work, but you could give it a try