esc cos problem
Thread Starter
Joined: Jun 2003
Posts: 6,279
Likes: 14
From: the garage
took it out last week and pulled up at a junction,then the revs went haywire and the engine died,started up again fine and been out a couple more times with everything fine but now its playing up again,ive stripped the i/s/c/valve and cleaned it all out,checked and gapped plugs ,checked all multiplugs etc,the 2 main loom plugs look fine but it doesnt seem to idle properly,and when changing up a gear seems to hesitate/misfire sometimes at low revs/boost,i tried holding the revs at 3 thou while it was stood in the garage but it kept fluctuating between 2.5 to 3 any ideas anyone? looks like it could be a trip up to stus if i can trust it to go that far
Hello mate, mine did nearly exactly the same as yours, started to be intermittent but then happened nearly everytime i took it out.
When you use part throttle does it feel jurky ??
Mine turned out to be the TPS, new on fitted it was good as gold !!
When you use part throttle does it feel jurky ??
Mine turned out to be the TPS, new on fitted it was good as gold !!
PassionFord Post Whore!!
Joined: Sep 2003
Posts: 4,519
Likes: 1
From: Macclesfield - you'll never leave....!
its not the colour that is important..... as both the 2wd and 4wd ones can be either red or black.
the part number is the important bit: 2wd: PF01. 4wd: PF09.
hth.
the part number is the important bit: 2wd: PF01. 4wd: PF09.
hth.
Thread
Thread Starter
Forum
Replies
Last Post
DavidK
Ford Sierra/Sapphire/RS500 Cosworth
1
Sep 27, 2015 02:55 PM
Russ Payne
Ford Sierra/Sapphire/RS500 Cosworth
1
Sep 25, 2015 08:29 PM






