Sierra Cosworth cylinder head removal questions.
#1
Virgin
Thread Starter
Join Date: Aug 2008
Location: East Yorkshire
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Sierra Cosworth cylinder head removal questions.
Hi Folks,
I’m looking for some direction as to a good link/page/article/book whatever that will tell me all I need to know and do to remove my cylinder head please. 3dr Sierra.
Do I leave the turbo and inlet manifold on? Do I need to have the car on a ramp (do I need to access anything from underneath). Is there anything to watch for?
Any help or advice appreciated.
Thanks
I’m looking for some direction as to a good link/page/article/book whatever that will tell me all I need to know and do to remove my cylinder head please. 3dr Sierra.
Do I leave the turbo and inlet manifold on? Do I need to have the car on a ramp (do I need to access anything from underneath). Is there anything to watch for?
Any help or advice appreciated.
Thanks
#2
I've found that life I needed.. It's HERE!!
Exhaust manifold is a pain in the arse to remove in situ, so I'd leave it on. Just disconnect the exhaust downpipe from the turbo.
You could leave the inlet manifold in place too, just disconnect the fuel and electrical connectors.
Not too bad a job if I'm.honest, even I can do it
You could leave the inlet manifold in place too, just disconnect the fuel and electrical connectors.
Not too bad a job if I'm.honest, even I can do it
Thread
Thread Starter
Forum
Replies
Last Post
snow*
Ford Sierra/Sapphire/RS500 Cosworth
9
30-05-2005 12:00 PM