zetec centre thrust shell cutout?
#1
Too many posts.. I need a life!!
Thread Starter
zetec centre thrust shell cutout?
well ive got new acl bearings to fit to my zt,
my block is a 2.0 and has not got a centre cutout to locate thrust shell but my new shell has a tab so physically doesnt fit
i have a spare 1.6 block i just pulled sump off to check and the block has a cutout but the genuine ford shell doesnt have a locating notch
would you try to grind my 2.0 block to accept the locator tab on my acl bearing
or
file the tab off the shell as they never had a tab on the original ford shells
many thanks dave
my block is a 2.0 and has not got a centre cutout to locate thrust shell but my new shell has a tab so physically doesnt fit
i have a spare 1.6 block i just pulled sump off to check and the block has a cutout but the genuine ford shell doesnt have a locating notch
would you try to grind my 2.0 block to accept the locator tab on my acl bearing
or
file the tab off the shell as they never had a tab on the original ford shells
many thanks dave
Thread
Thread Starter
Forum
Replies
Last Post
SMILER258
Restorations, Rebuilds & Projects.
36
28-09-2015 09:04 AM