Hi there ...

I am attempting to build a highpower Zetec blactop N/A engine. And now i am almost only down to wich injectorsize i am going to use?


A little facts about the engine - Fully rebuilt Blacktop Zetec 2 litre with:

* JE Pistons

* Eagle Rods

* Knife-edged crank

* Fully Arp bolted

* Mashined and ported head with standard size valves - 3 angle valve seats

* Not sure about the cams yet, but was thinking Newman cams - 280/270 (In/out)

Any advise on theese?

* 45 mm Toyota throttlebodies

* 80 mm trumpets for the tb's

* Homemade "plenum" for the tb's

* Homemade intake manifold

* 4 to 1 Fourbranch manifold in stainless steel.

* Homemade 2,5" stainless steel exhaust with a Mongoose backbox

* And finally a Megasquirt Extra Ecu or a Omex 500



So the question is - wich injector size should i go with? And what about the cams?



All of this is going into my S2 ...



And a link to the car

https://passionford.com/forum/restor...on-wheels.html