hi peeps
is this the right way to remove the abs from a series 2
1) remove pumps
2) change fluid res to a xr3 coz of return pipes from pumps
3)2 new pipes from the 2 outlets from master cylinder ,one to each t piece/distributor to front and back brakes on the inner wings
also can i reuse the the nuts/joiners to do this but use new pipe and flare it to fit

any help would be grateful
mark2

 

It's a long time since I done it on my old one but that's the gist of it yes (although some just loop the reservoir returns together with a short piece of hose).

You want to reuse the male/female unions?... they're dirt cheap from most motor factors so may as well replace as well (they get pretty rusty after 18yrs or so!!!)

 

cheers fella will renew male and female connections as its a good point stated
mark