Rick

My exhasut is blowing where the custom down pipe has been made, through some of the welds. Tried to seal it with some gum gum paste, but i thin its got too hot and flaked off. Anyone recommend anything? Maybe something that doesnt set hard?

Al Bags

Nope ... Cant you reweld after a clean .. in situ (with a MIG)??

Puss2

iTrader: (5)

how long have you had exhaust on? would whoever made it do it under a warranty

Al Bags

It's home-made mate, isn't it?! So you have to fix it yourself

markk

iTrader: (2)

use a high modulous bathroom sealant mate, and before you start laughing, and then telling me not to be stupid, try it, the stuff im on about smells very strong,

im now going to say no more about it, only how hot do you think it gets between my manifold and the head on the car in my sig, when its done a 10 mile stage with als on ?


trust me



p.s dont tell everyone - just leave it for abotu 30mins to cure, and then let it warm up before revin the stones off it, you will never ever use exhaust paste ever again, or even exh gasket pal

AJC

iTrader: (6)

bathroom sealant

GrimmeRS2K

id believe him, ive used it to seal a middle section before, i know its not as hot there, but it never leaked again and didnt go all flakey

Rich_w

OK then, I'll humour you what brand?

markk

iTrader: (2)

aslong as its high modulous

what ever you like m8 !

but how about at my cylinder heads exhaust ports ? well hot ?

Rick

High modulous? Does it say it on it - what does that mean?! What about RTV silicone?

NUTS RuS

iTrader: (35)

Do you want me to pick up the Rad this weekend Rick ?

Rick

Tony - this one is holding at the mo - i think lol. How much u want for it?

Sticky.

iTrader: (4)

Use some No Nails on it, that'll seal it up

markk

iTrader: (2)

take the top off and smell it - if you screw your face up after a good whiff - that stuff will do !

RS ONION

ha ha i was gona say that , then ud neva get the fooker off !!