righthooker

Started working on my 3 door track car this week , stripping down what i dont need and getting it read to go to Jacko for paint.
The loom is ropey as are most and i am sure there is stuff on it that i may no longer need.
I was wondering if it is maybe an option to take it all out and get one done with just the bare min requirements.
What do you recon , too much work, too exspensive , silly idea, not possible, oppinions please

charlie luciano

iTrader: (3)

A replacement loom is always a good thing


Luciano

righthooker

Iwas going for a new engine loom anyhow, but i am just thinking of all the other bits i wont need.
Anyone done this befor??

tabetha

Roosie is doing it as well, on his 3 door track car, good idea imo if not needed, less to go wrong.
tabetha

philram

iTrader: (3)

i'm going to use a basic 1.6 loom, with the engine loom attached.

Rs1

iTrader: (1)

Its a bit time consuming if you want to make it look nice....braided up or raychem'd etc but its not overly expensive.
For a basic setup i'd just run a relay box with fused relays, its fairly neat and tidy solution.
Parts available from... vehicle wiring products and polevolt.

righthooker

Will have to look into it , as i would never tackle it myself.
Will have to speake to the boys see who may be up for the challenge

mad dog younge

clive give lew e a ring .he will do yours for you

righthooker

Was thinking of you and lew, do you think it would be achievable mate and not a bit over the top to re do the car .
That way i could get the loom out and crack on.
You know the score i will always take advice and offers of assistance

You got any dollys left so could drop the running gear mate or a spit knocking about??