can I feed the secs monitor rpm signal from the wasted spark driver's rev counter output or will it end in tears

 

Trev........

You can mod the cossie revcounter to work with the SECS driver output,also the early drivers needed a small mod to them as well...

Give us a min and i`ll see if i can find the details...

 

Doh........

Just realised what you meant......My monitor only reads half revs from the driver revcounter output,don`t think they will work with the wasted spark conversion....

 

but your secs is still getting the signal from one of the ignition amps, not from pin 21 the dedicated rev counter driver, so if connect the secs to pin 21 will it read correct rpm?

 

go on try it

just put a 30amp fuse in the link so at least it wont catch fire

 

em if I was brave enough to try it mate I wouldnt be asking the question, I might be asking how much a new secs monitor or wasted spark board is though

 

 

It will end in tears

I have just restarted the monitor business with new manufacturers.

There will be a software upgrade available very soon for old monitors
to make the display read correctly for wasted spark drivers.

Just waiting for a batch of new chips from the USA to arrive.

(These are on a 12 week lead time )

Should be available within then next few weeks

 

at least it is possible

 

Simon any chance on a price reduction

Dave

 

It you want to buy a quantity maybe...

 

excellent news simon, will the upgrade be through you or a distributor and will you let us know when and who etc? Must be quite a few people with the same problem as me!

 

Electronic
can u tell me what the reading for the rpm on the secs monitor should be with coil pack,half or full cos mine is readind full

 

Jason thas some sig you have there

 

I will be interested in this if it ever comes through lol as i have no rev counter at all at the mo

 

jason 3dr excellent sig

 

Where is it I can't see anything