had the beantin on the rollers today
#1
Thread Starter
PassionFord Post Whore!!
iTrader: (3)
Joined: Apr 2004
Posts: 8,223
Likes: 1
From: Northants
had the beantin on the rollers today
all good i just thought i would get it checked out to make sure it was all happy, only needed to adjust the mixture & idle a little but everything else was ok
still not running a lot of boost, it peaks 17psi then drops to 15, it made 211bhp & 229lbs/ft. It didn't have much more fuelling to run any more boost, was thinking of getting a 5th injector but i really have to sell it soon i'll just enjoy it for now
still not running a lot of boost, it peaks 17psi then drops to 15, it made 211bhp & 229lbs/ft. It didn't have much more fuelling to run any more boost, was thinking of getting a 5th injector but i really have to sell it soon i'll just enjoy it for now
#5
Thread Starter
PassionFord Post Whore!!
iTrader: (3)
Joined: Apr 2004
Posts: 8,223
Likes: 1
From: Northants
Eagle, Pennywise, its a low comp 1600 CVH, steel rods, stage 4 big valve head, stage 3 T3 etc...
Oranoco
thats the problem Steve, always wanting a bit more i'm a bit snookered for room at the moment so one of them has to go soon, otherwise i would do a bit more & gun for at least 250bhp.
Oranoco
thats the problem Steve, always wanting a bit more i'm a bit snookered for room at the moment so one of them has to go soon, otherwise i would do a bit more & gun for at least 250bhp.
#7
looks like you need a lot more fuel then to get that to goto full potential ..
shame you have to get rid ..
i keep getting the idea of dumping the cossie for another bean tin
shame you have to get rid ..
i keep getting the idea of dumping the cossie for another bean tin
Thread
Thread Starter
Forum
Replies
Last Post
rsguy
General Car Related Discussion.
44
29-09-2015 03:29 PM