jacko

these are a limmited amount of liffters that i have came accross and they have the usual hydrolic designe but allso have a bearing at the bottom so they dont wear thecam loabs down i do not know what make they are but they look good quallity ring me on 07757722264 i will get some pics tomorow

jacko

just to add that they can be taken apart to be cleaned

Christian and Beccy

iTrader: (14)

Jacko, sorry to say this, but you should point out that these cannot be used with a normal CVH cam. They aren't really a practical option for any RST owner.

I wouldn't normally jump on a thread like this, but I would hate to see any backlash and problems for you.

jacko

why whats up with them mate as i said iv never seen them before

Rick

designed for the 1800 sierra engine - which isn't really anything like the FWD CVH's

jacko

im going to test these next week to see what happens before i sell any more

Christian and Beccy

iTrader: (14)

When you say 'any more', have you already sold some of these??!!

jacko

1 set but no more will be sold till iv tried them my self

jacko

these have been tested and are fine no less noise though

Fiecos Dan

Sorry 2 days isn't a test.


give it 6k miles and 6 months.

jacko

its been 2 weeks mate but i ment tested with a foot down hard

Christian and Beccy

iTrader: (14)

It's only been 9 days since you said you were going to test them 'next week'??

What kind of testing are you doing? Are you assuming that just because the engine hasn't shat itself that they are OK? Have you removed and inspected the cam/followers yet?

jacko

i was going to test them but a mate got some off the same guy for his zvh turbo and they are fine and he kanes the life out of his car every time he drives it i proberbly can get him to take them out and check them see how they are doing but seen as its running fine i dont think there has been any damage they aint noisy and there is no difference in the way it runs