brizie

Anyone any pics or tips on replacing the rear legs?

Can't believe what shite you find after scrapping off the underseal!! wish i left the fucker alone

Red_bull

Take a drill and drill holes on all the places where they have been spot welded. take a good look of where all the holes and exhaust mounts so they are on the same place on the new onces.

That are my tips

brizie

I'm guessing i should brace the shell before removing the legs?

anodised

i think u need a jig tbh

Red_bull

i've made a frame where i could mount the car on the brackets of the swingarms, but my car was totally stripped

mark2

hi fella
get it done buy a mot welder
my mate had his done and kept going through one rear tyre and when he decided to get the tracking done he found out why the hard way
mark2

brizie

Come on surely someones changed the rear legs before and can give some guidance!!!

SillyFezzaMk1

iTrader: (1)

If they're not too bad then plate them up as theyre a pig to change.

Dan

Red_bull

i think when you don't do them totally rust will always come again in short time. They are really rusty inside! you can't see it. When i removed them you saw how much rust was in them on some places!

brizie

Could i just replace the rotton section with a cut off from a new leg?

redbull any pics of your frame you made?

Red_bull

You could deff replace a part but i think there's rust all over the place on the inside of them. So when you need to do is and allready have to buy new parts why don't you do the whole chassis rail? Else you do a part now and over 1,5 year you have to replace it again on a other place..