oakey dokey

hi to all i was thinking of rebuilding mr erst but now think that the zetec route would be better so just looking for info on what i need to buy and so on!!

firstly i know i need the engine itself but what else do i need! i take it ill need frst loom and ecu?

what about the inlet manifold,pistons,headgasket...ect

all help would be greatful

many thanks

RST Ski

you will need efi or some other managment (manifold ect) and the compression and stronger head gasket will need to be changed to cope with the boost

davidnormanuk

Can Fiesta Management be used then on a Zetec tubo engine or will it need to be remapped?

Cheers
Dave

RST Ski

yes frst efi managment will work, im sure it would need a setup aswell

davidnormanuk

Need another project. Might look into that a bit more then. did Ford make a 24v zetec engine?

RST Ski

duratec v6 i think

oakey dokey

thanks lads but this doesnt help me!!!

Red16

do some bloody research, its been covered on here time and time again