program for remap weber marelli
#1
Part of the Furniture
Thread Starter
iTrader: (1)
Join Date: Mar 2008
Location: Sweden
Posts: 154
Likes: 0
Received 0 Likes
on
0 Posts
program for remap weber marelli
What programs are avalible to remap and do custom maps to weber marelli,both p8 and l8.Rp lab is not what i want because u can only use the box that they have modified.I want something for my laptop to conncet to the ecu L8/P8 and tune it live.
#6
Too many posts.. I need a life!!
Join Date: May 2004
Location: in the garage fixing yet another oil leak
Posts: 925
Likes: 0
Received 0 Likes
on
0 Posts
there is some stuff here about stock cosworth ecu's which you may fidn helpful
http://www.bigturbo.co.uk/
http://www.bigturbo.co.uk/
#7
Part of the Furniture
Thread Starter
iTrader: (1)
Join Date: Mar 2008
Location: Sweden
Posts: 154
Likes: 0
Received 0 Likes
on
0 Posts
there is some stuff here about stock cosworth ecu's which you may fidn helpful
http://www.bigturbo.co.uk/
http://www.bigturbo.co.uk/
Trending Topics
#8
Colossal Pervert
TunerPro will do the job if you can be arsed to spend the time writing teh definition file (table locations are available, like in that bigturbo.co.uk site)... But there are no decent emulators out there that support realtime tracing at present (the moates one is crap).
#11
PassionFord Post Whore!!
Join Date: Sep 2003
Location: Macclesfield - you'll never leave....!
Posts: 4,519
Likes: 0
Received 1 Like
on
1 Post
true - but how many ecus do you want to map - if just the one on your own car then its a very cost effectove route if you already have a L8 - as you need no new sensors, loom or hardware other than ther interface unit
#15
Ask me a question!
iTrader: (1)
IEMSP8 is the software you need with hardware.
Then you need the keys for the base chips you want.
Then you need some way of writing the eprom like and S4.
Then some experiance.
Not as easy as it all sounds
I have all the keys hardware and software, not just for Pectel but for some collins boards and also STD baby boards for the L8.
Regards
Jano
Then you need the keys for the base chips you want.
Then you need some way of writing the eprom like and S4.
Then some experiance.
Not as easy as it all sounds
I have all the keys hardware and software, not just for Pectel but for some collins boards and also STD baby boards for the L8.
Regards
Jano
Thread
Thread Starter
Forum
Replies
Last Post