Hi Folks,
I’m looking for some direction as to a good link/page/article/book whatever that will tell me all I need to know and do to remove my cylinder head please. 3dr Sierra.
Do I leave the turbo and inlet manifold on? Do I need to have the car on a ramp (do I need to access anything from underneath). Is there anything to watch for?

Any help or advice appreciated.
Thanks

 

Exhaust manifold is a pain in the arse to remove in situ, so I'd leave it on. Just disconnect the exhaust downpipe from the turbo.
You could leave the inlet manifold in place too, just disconnect the fuel and electrical connectors.
Not too bad a job if I'm.honest, even I can do it

 

This would help Workshop manual