My brother has asked me to sell his turbo for him, that was going to go on his Escos, but he sold it a few months ago.

GT35 hybrid, 360deg thrust bearing, polished housing, AR 0.63. It may have cutback blades, but he can't remeber, and not sure how you tell? Will take another closer photo of blades later.

Any ideas people?

 

I think this is a t34/35 mate gt turbo's are roller bearing cored and I don't think I've seen a internally gated one yet.

Ł250/ Ł300 for a t34

 

I'm on that thought also.I've never seen an internally gated GT35

 

im looking for a t34 for my 2wd saph, if this will fit?

 

Fair enough, only going on what my brother remembers/told me. Not a turbo expert myself.

 

defo looks like a t34.63
prices above are about right

if it was a internal gate gt35 it would be worth a forune
but the size of the compressor housing would be a lot bigger if it was a gt35

 

is this a lambda sensor?



and some more of the blades.







for any who enquired, I have to check with my brother who is 12 hours behind us at the moment, so responses will not be quick.

 

yes thats a lambda sensor
blades look standard to me

 

Rear blades are cut back.

usually done at 7 degrees but no guarentee these are.

 

if these blades are cut back then maybe mine are as well
as i'm just going by comparing it to mine

the ones i've seen before were at a greater angle than that but i'm no expert