outlook31

I have just replaced the injector seals/washers and put the car back together minus the air filter and surround. I have hand pumped the fuel (fuel bulb on fuel line)and the car (1.4 tdci Van) will not start. I cracked the fuel input to the injectors one by one and still nothing (fuel came out when engine turned over).
I am now at my wits end, am not sure what todo next? Does anyone have any ideas?
Happy New Year to all.

cossyking

alot of fords need injectors reprograming when disconnected but i think your 1.4 is a peugeot engine so it should be fine ive had problems with these and the 1.6 when ive changed engines best bet is to give it a tow if you can and it will prob go

Ianw1958

my 1.4tdci needs bleeding to get it going,once bled runs fine,just had fuel leak from injector fixed ,new leak off pipes fitted,checked and rechecked ,got it to go for 2days without probs then start again.fuel return conector(green) doesnt appear to have an "O"ring in connector ,should it have? any help welcome ,seem to be lots of questions but very few answers

carlfiesta999

another old post ressurected

Ianw1958

Ive seen plenty of posts, does anyone have any answers? ,can you just buy a priming bulb or is the whole kit needed(£123.00) from fords