Right im wiring my loom in and got the full dash and engine bay loom wired in. Everything works except the following:

Heater blower at 1&2(works fine on 3-full blast)
Clock backlight(not the bulb cus ive checked)
Washer jets(not the motor either cus ive got two that were both working)

Any ideas as to what could be the problems? Just had to rip my dash out to start tracing them again but theres nothing thats out of the ordinary Everything else works fine

 

Heater blower relies heavily on the connections being on the right pins.

Are the clocks earthed ? Check back from the multi plug.

Is the washer motor getting a signal from the wiper stalk ?