Custom Inlet for Bike Bodies??
#1
PassionFord Post Whore!!
Thread Starter
Join Date: May 2003
Location: Lincoln & Scunny
Posts: 4,117
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://passionford.com/forum/images/icons/icon1.gif)
If I was to fabricate (or at least have one done) a custom inlet manifold for a set of Bike bodies, would it effect the flow much IF is was to angle them upwards it would probably mean cutting the tracts and angling them...
Would the fact that it was cut and set at an angle interupt the flow to a degree where by it was a disadvantage?
It's on a 2 ltr zetec, on a mk2 XR2 by the way...
Thanks for any input
Would the fact that it was cut and set at an angle interupt the flow to a degree where by it was a disadvantage?
It's on a 2 ltr zetec, on a mk2 XR2 by the way...
Thanks for any input
![Big Grin](https://passionford.com/forum/images/smilies/icon_mrgreen.gif)
Thread
Thread Starter
Forum
Replies
Last Post