'06 Focus, DTC engine codes problem
#1
Virgin
Thread Starter
Join Date: Mar 2021
Location: Helgeroa
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
'06 Focus, DTC engine codes problem
I have had an issue with my '06 Focus 1.6 TDCI for a while.
Several DTC's are detected, but replacing the sensors involved with DTC codes don't do anything.
The codes are:
P0100 Mass/Volum air flow A error
P0102 MAF sensor circuit low input
P0113 IAT Sensor circuit high input
Has anyone experienced other systems that could cause these codes ?
Could it be a problem with the EGR or the DPF system that are causing these codes ?
Any help is much appreciated.
Several DTC's are detected, but replacing the sensors involved with DTC codes don't do anything.
The codes are:
P0100 Mass/Volum air flow A error
P0102 MAF sensor circuit low input
P0113 IAT Sensor circuit high input
Has anyone experienced other systems that could cause these codes ?
Could it be a problem with the EGR or the DPF system that are causing these codes ?
Any help is much appreciated.
Last edited by Vikane; 22-08-2021 at 05:29 PM. Reason: wrong model year
#2
I've found that life I needed.. It's HERE!!
These faults could be the result of a wiring problem, particularly a missing (common) ground.
No other part (like EGR or DPF) can cause the P0113, because the high signal means stands for a very low temperature.
No other part (like EGR or DPF) can cause the P0113, because the high signal means stands for a very low temperature.
#3
Virgin
Thread Starter
Join Date: Mar 2021
Location: Helgeroa
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for your reply.
I have tried to locate and check all visible ground connections, but it might be one that I have missed.
Any chance I could find a complete overview for all earth connections for this car somewhere ?
Thread
Thread Starter
Forum
Replies
Last Post
paceo
General Car Related Discussion.
14
28-03-2007 04:31 PM