B&M shifter fitting problems.
Thread Starter
Stealth, like a Ninja.
Joined: Oct 2014
Posts: 14
Likes: 1
From: Deal, Kent. On loan from Manchester.
B&M shifter fitting problems.
I'm hoping someone can help me with this.
I'm trying to fit a B&M shifter to my 1989 XR3i cabby but when I fasten the stabiliser and linkage rod in place the shifter is too far back in the cabin and won't bolt up.
At the moment it's bolted in place in the cabin, and the selector rod is in place, but the stabiliser bar is about 6mm too far forward on the gearbox.
Any help is appreciated as its driving me nuts!
Cheers.
I'm trying to fit a B&M shifter to my 1989 XR3i cabby but when I fasten the stabiliser and linkage rod in place the shifter is too far back in the cabin and won't bolt up.
At the moment it's bolted in place in the cabin, and the selector rod is in place, but the stabiliser bar is about 6mm too far forward on the gearbox.
Any help is appreciated as its driving me nuts!
Cheers.
Thread
Thread Starter
Forum
Replies
Last Post
marky_g
General Car Related Discussion.
10
Aug 15, 2015 10:43 AM
track.focus'd
Restorations, Rebuilds & Projects.
26
Aug 12, 2015 05:53 PM