3 bar MAP sensor
02-10-2011, 05:48 PM
#1
Virgin
Thread Starter
Join Date: Oct 2011
Location: indonesia
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
3 bar MAP sensor
Hi everyone...
Just need some information regarding tuning the ford escort cosworth to gain more hp..
I have seen the most common mods is by getting -31 actuator, 803 dark green injector, fuel pump and 3 bar MAP sensor, then increase the boost.
My question is : if I already use a haltech (fully programmable aftermarket ecu) to replace the standard ECU and already installing a haltech boost control solenoid to increase the boost to 1.3 BAR, do I still need to get the 3 bar MAP sensor? ( I mean does the 3 bar MAP sensor only necessary if I still use a standard ecu and using a chip to increase the boost )
Hope to get great informations...thank you...
Just need some information regarding tuning the ford escort cosworth to gain more hp..
I have seen the most common mods is by getting -31 actuator, 803 dark green injector, fuel pump and 3 bar MAP sensor, then increase the boost.
My question is : if I already use a haltech (fully programmable aftermarket ecu) to replace the standard ECU and already installing a haltech boost control solenoid to increase the boost to 1.3 BAR, do I still need to get the 3 bar MAP sensor? ( I mean does the 3 bar MAP sensor only necessary if I still use a standard ecu and using a chip to increase the boost )
Hope to get great informations...thank you...
Thread
Thread Starter
Forum
Replies
Last Post