i have just aquired a set of pepper pots with tyres of my bosses dad just have to do a 5 hour clutch job 4 him suits me any day lol

i have plans to fit 50 mm lowering springs with the xr2 pepper pots but wanted my car to have the euro look with wheels prutruding the arches as vosa now states in an mot the wheels can prutrude the car but can not have any sharp edges is there any spacers i can by that will give me a bit of a wide look without stressing my wheel bearings to the max
cheers lads

 

Loads of spacers you can get, easy to make as well if you can't get the width you want.
Put studs in the hub and progressively add washers between the wheel and hub face until you get the "stickyoutness" you want then measure the thickness buy spacers that width.
Any deviation away from the perfect 0 ET will have an effect just have to live with it bearing life wise.
tabetha

 

cheers for ya help