Just done a zetec conversion on my mk4 cab, It was a 1.6 mfi and now i have fitted a early 1.8 130bhp zetec on standard management. Anyway i cant get the rev counter to work properly, I can get it to work but not showing the correct rpm. I have 5 sets of clocks and all do the same also changed the filter or suppressor thing but no different.

I have read somewhere before that a direct feed from pin eleven on edis module will work but i cant get any reading at all from pin 11 (green wire).

I know many people have done this conversion now and hope this is something simple and someone can help.