nealo

hey guys, im having a replacement engine fitted to my rst and am wondering if my chipped ecu will be ok running it?

my last engine was the same besides kent cams,ap clutch and vernier pulleys. Obviously i know every engine is different so the maps/fueling is slightly different but i want to know if my old setup chip should be ok running the replacement engine for a bit until i have it set up properly by MSD?

Thanks

tabetha

So long as you can restrain your right foot, it would be ok for running in new engine.
tabetha

nealo

its not running it in, the new engine already has 14k miles on the clock so has been ran in and previous setup. im asking if it would be ok for the chip to run the engine?

tabetha

NO absolutely not, may be somewhere near but will defo need checking, with different cam no doubt it will need changing, I would speak to stu/msd.
tabetha

nealo

I have sent him a PM il give MSD a call as he hasnt got back to me this week.

The technical section on this website is REALLY slow isnt it lol.