crazydan

im planing to start building a 2.0 zetec mid this year im hopeing for around 400bhp this is wat im planing to do to get that power
2.0zetec
rebore to a 2.1
steel con rods
forgd pistons
acrelit piston rings
MULTI-SHIM head gasket
stage 3 head
fast road cam
titanium vavle springs
twin 45's (and manigment system)
full stainless system
STEEL FLYWHEEL

i think thats it
so wot power do u think i would get from that?
and wot clutch would i hafto use to cope with the power?
any help would be great thanks
Dan
p.s excus the spelling

binman jim

better off using throttle bodies instead of carbs and i reckon u'll see 300bhp tops. u'd need to use turbo power to get over 300 from a zetec.

crazydan

really i was thinking that
dont no enough about setting up turbos at the momment
oh well better start studing :L
thanks anyway binman jim
Dan

*Bri.4.b.Cos*

Think on the twin 45's realisticly looking at 200bhp max with out silly rev's

vibrating_cake

twin 45's port n polish exhaust = 200bhp FTW

any more you'll be looking at raising the capability of the engine to go to ~9000rpm with silly cams etc, but i very much doubt you'll reach anywhere near 300bhp without a turbo.... or supercharger

Ade

You'll never see 400BHP NA from a Zetec

More like 200 BHP from that spec.