hi peeps was working on a zetec turbo conversion today put engine in conected up the already installed omex managment and when i turn the ignition on the fuel pump runs constantly and the injectors constantly fire?
the serial number on the ecu is 608 500c does any one know weather this is a 500 or a 600 series and if there is an omex forum as i have not got a clue whats going on and have never used omex managment before.

also has any one got the software as this may be able to tell me the readings each sensor is getting

 

Ring omex, they are very friendly people....only down the road from me

 

http://www.omextechnology.co.uk/Ecus/ecus.htm
try there website,downloads on there too.
seem ok to deal with,not very good at sending maps out though.
i run my mg maestro turbo on omex 600 and it flies
hope this helps
dave