vinnyd

hey ppl i thought i had sorted my starting problem on the cossie, i replaced the two wires from the crank sensor and it started, but onec i put them neat in the loom the same problem has happend...AAAARHHHH..

i done that check test on the ecu plug, but i am not getting a voltage from the trigger wires which go to the ignition amp module, plus when i short them out i do not get a spark whch it should do if its done manually!!

does anyone know or could try this for me, i am just trying to see if the LED tester would bring a crank fault up if the module doesnt work!!

cos there is no fault code for the module so i am assuming that it will bring the next thing up what it cant see???

cheers..