im going to be doing a 2.0l engine conversion on my mk6 fiesta i have a focus 2.0l donnor car rear ended i no i could just do a st150 coversion but allready got the dnnor car just woundering about the drive shafts will the focus ones fit ? for the wireing iv got the haynes manual for the fiesta and the focus so will use that to see what wires are what im geting a 421 manifold as well and im just got to modifie the fiesta exhaust to fit because iv allready got a magnex on .. so any tips will help just need to no about the drive shafts

jamie

 

Keep your driveshafts. The Focus engine bolts right onto your gearbox bellhousing.

But will be a pain in the arse to fit the electronic...

 

right thanks so the drive shaft will fit the focus gear box? heres a pic off the engine im pulling out off the fiesta mk6 its already throttle cable so no messing about there

the engine:



the car st replica:

 

Gearboxes are the same, might be some differences with the mountings.

Engine bolts right onto your gearbox, so keep it and throw just the engine out!