Hi
Had the underside of my car sand blasted not so long ago and the man said the stuff under the wings is Bullet proof. (He’s not far out)
Any one out there know of any think that will take this off other than a blow torch and wire wheel brush on a drill

 

nope

 

i got mine off with paint stripper but not nitromors it was from a panel supplier and was just called heavy duty paint stripper its for 2k paint systems but you got 2 b careful as its extremely strong

 

The way i get it off is to warm it up with a blow torch or hot air gun, once it starts to smoke use a scraper to scrape it off, after most of it is off use a wire brush to tidy it up.

 

Just perseverence really. I did this job only yesterday and it needs a good wire brush in an electric drill working it slowly.

 

cant u not leave the stuff on and put a new layer off the top.

 

Heat the opposite side of the panel (the bit that doesn't have the sealer on) up with a heat gun and you will see the sealer blister and start to peel off itself. Use a scraper and it will just come straight off.

 

I would leave it on mate and just scrub it clean and paint over it because if you take it off you are taking away the floors protection and then you can hear every stone clank onto your floor when driving