cossie04

iTrader: (1)

Took some photos of my car the other day, and before i had a chance to post them, i ended up twatting it....










After:











I've already bought most of the panels, i've already replaced the the bar on the rear swing axle to straighten the rear wheel, but the only thing i`m wondering about is the sill section... Just need to find some bumpers now.

cossie04

iTrader: (1)

Sorry, wrong room really....

Anonymous

shit not good mate

Greg Shepherd

not good ed

wehat happened

Jade1

Im not that fond of Mondeos but that is fooking lush.

Sorry to hear about the damage

dakar

iTrader: (1)

Looks bad that mate how did u manage that

cossie04

iTrader: (1)

I managed to come too fast into a sharp right, braked hard and it started to twitch then slid sidways at about 50mph and hit 2 small trees and landed on a football greenon the other side of a hedge. We were then stuck locked in this football pitch so we had to breakout of there before the old bill turned. Ended up smashing one of their bollards out of the ground.

cossie04

iTrader: (1)

Greg Shepherd

Hello mate, how are you?

Sukhy RS

Not good that Ed, Looked lovely before aswell

steviecossie

hope you get it fixed mate

dave cos4x4

iTrader: (5)

it looked fookin good aswell.

well and truely fooked it.

Fiddy

shame, gutted for you fella.

RST-Steve

Ouch!!!

Not good fella, hope you get it all sorted ok!

Brian

iTrader: (2)

Gutted for you mate

Looked mint

Hope you get it sorted



Brian

The Youth.

iTrader: (1)

were you not fully comp
as that is in the eyes of insurance "uneconomical to repair" ie it's a write off!

gutted to see an st200 fooked, will be my next runaround car.

steve

cossie04

iTrader: (1)

I am fully comp, but it will be cheap for me to repair it myself as i worked in a bodyshop for 3 years. Putting it on a ramp in the next couple of days to inspect the n/s sill section and floor.

Harris.

opps

bookwyse

As the owner of three 200's its sad to see one like that.

But as for sympathy, no way. Going into a sharp corner at 50 is asking for trouble. I dread to think what would have happened if anyone had been on the field at the time!!!!!!!!!!!

As for repairing it, I wouldnt bother as it will be hard to get that chassis straight after a smack like that.

martrs

glad you are ok and hope you get it sorted

RichieST

iTrader: (2)

bloody hell you have done that good and proper! shame cos it was a good looking motor...

Surely the sill section is far too fooked to consider fixing??

AlexD

iTrader: (3)

Thats fucked it then..

GazzaG

sorry to hear that ed

as others have said, really its not worth repairing due to the smack, and the sill, the panels may never line up right again, it may not drive the same ether

looked mint before aswell fella,

hope you sort it soon,

hopefully that floor wont be bent but i wouldent count on it

bookwyse

Whats with pulling the plates off. Hoping that coppers wont recognise you!!!!!!!!!

cossie04

iTrader: (1)

No, theres nothing left of the front one and the back one managed to lose a screw so took it off when i got home.

We have taken the sideskirt off and inspected the sill and is not as bad as i first thought. i have managed to source all panels apart from the rear bumper for a meer Ł165! The rear wheel now sits straight and drives in a perfect straight line down the road.

Will keep you informed how it goes.....

fatboy billy

foook gutted for ya ed was a minter were abouts you stack it????

cozzie4d

ooch

hope you get it back in it's nice state again..