DUDE_SWEET_FRST

the way i see it... (2L zetec turbo engine. brand new everything)

im going to put in 100% mineral 10w40 oil it to begin with. remove coil pack sensor, remove fuel pump replay. and give it a good cranking over (say maybe 10 - 15 seconds??)

replace them. then fire it up

let it run for half an hour / to an hour. then dump all the oil and change filter

does that sound ok for the initial start up of the car?

im shitting it

Fudgey

iTrader: (4)

crank it over till the oil light goes out mate.

then fire it up.

have you got brand new cams too?

if so it will need to reved at 2.5k rpm for 20 mins to bed the cam in.

then take it for a blat

GARETH T

ask yourself what you are "running in"

Fudgey

iTrader: (4)

cams and piston rings lol

Anonymous

(never thought that the day would come where i would say this but....)


I agree totally with Dan

Fudgey

iTrader: (4)

ha, not even if we were at a pizza place and they only had one on the menu...

actually ignore that, cos you dont have the tomato base bit

GARETH T

the reason i wrote that was because of this
and yes,, i also agree with dan

Anonymous

<-- Real tears, at the irony of that example

jon@work

iTrader: (5)

Pull the spark plugs out before cranking it over to bring up the oil pressure. Will probably need over 30 seconds for the light to go out.

DUDE_SWEET_FRST

the engine

thansk for the advice guys

morto

sounds good dude, as said if cam is new rev at specifieid revs for 20 mins lol good luck, i was shitin it when i put my brand new hybrid turbo on but all was ok, infact everytime the cam belt comes off i brick it when i start it up lol

andy

stoo2000

http://www.escortevolution.co.uk/for...howtopic=58021
take a look ^