Neil S

iTrader: (1)

Is it as simple as it looks to swap exhaust housings?

i.e. unbolt the housing and lift it off the core squarely so as not to damage the blades?



Neil.

churchy

I sure do hope so

Rick

compressor housing is easy, exhasut is a twat.

Neil S

iTrader: (1)

Because you can't remove the bolts fully as they foul the oil feed and water drain, or for some other reason?

Neil.

dannyblackpool

yeah bolts need loosenen till hit core then rotate core till bolts can be fully removed. Core assemblies more or less weld themselves to the ex housing though so dont think it will be easy to split

Rick

It's because its so tight - its fused on with the heat. U need to smack it like hell to get it to twist on the core. The bolts will come out - u just need to rotate the core to a position where they will.

cossie4i+

iTrader: (15)

You can do it but be very careful, a small piece of the flange on the centre core of mine broke off

Soak around the housing in WD40 or something,as mine would not come apart until it had been left for a time.

Turbo still works ok

Steve.

dannyblackpool

get a lump hammer and smash the fuck out of turbo, it will split then .................. into around 8 peices

Neil S

iTrader: (1)

Mine is brand spanker, so should come off easy.

Churchy may well be screwed though!!!

Neil.

Rick

lol - if anyone got a 63 housin i need one

Neil S

iTrader: (1)

Shush, I bagged Churchy's first!

Neil S

iTrader: (1)

PS, there's a .63 on Fleabay presently:

http://cgi.ebay.co.uk/new-cosworth-6...QQcmdZViewItem



Neil.

RichardPON

Mine was real easy - boxed it and sent it to Universal Turbos!

churchy

That is purly because your head resembles a testicle



I'll be fine, may apply some heat first to loosen it all up Then treat it to a shit load of WD40, then get ole sledgy on the task