leecavturbo

i have my engine ready for mapping on a dyno
in tamworth staffs but the dyno owner has no turbo mapping experience only N/A stuff,
whilst he is confident to map it ,i wanted someone who has the experience such as stu or mark ,so who can do it? and when
should be intresting for who ever maps it, i hope to be running 370+bhp 320+ft/lb
" fully professional dyno cell/suite btw"
short spec / all brand new never run yet.
GT2540R turbo .7 & .86A/R on custom manifold iirc 44-48lb/min
Je's 7.9:1 on arrow rods,arps etc
ported & bench flowed head
full crank and alu fly wheel balance
DTA P8PRO ecu, professional loom
500cc injectors
water inj if needed/safety margin
Nos for use as antilag to get that semi big turbo spinning if needed,
To finish: 3 Bar map sensor,

ECU Monitor Enthusiast

iTrader: (1)

What make engine is it ???????

You will pay big money for a "pro mapper" to travel to use unknown equipment on an unknown engine.
Even then, you would probally have to book weeks in advance.

Expect to pay at least £400 + expenses !!!

I have worked with many of the well known mappers and they tend to stick to there own areas/premises.

I have done mapping myself but only on my own engines as its my own risk !!

Best bet is to call people directly. It is unlikely that money will be discussed in a public place. !!

Good luck