Anyone plumbed in a boost controller, advice ?
03-03-2013, 05:39 PM
#1
just finding my feet
Thread Starter
Anyone plumbed in a boost controller, advice ?
Has anyone fitted one,,, need advice on plumbing it in as the 2 port has confused me
I think I plumb compressor to solonoid "in" and the go from"out " to actuator
The little ecu then goes to eithe inlet or t off from compressor,,,,, I'm lost lol
I think I plumb compressor to solonoid "in" and the go from"out " to actuator
The little ecu then goes to eithe inlet or t off from compressor,,,,, I'm lost lol
03-03-2013, 05:56 PM
#3
Generally;
In = Turbo Compressor Housing
Out = Actuator
Then a small capillary feed for the controller itself should be taken from the inlet manifold after the throttle body.
Which boost controller are you using?
Is it a single port actuator?
Rich
In = Turbo Compressor Housing
Out = Actuator
Then a small capillary feed for the controller itself should be taken from the inlet manifold after the throttle body.
Which boost controller are you using?
Is it a single port actuator?
Rich
03-03-2013, 06:27 PM
#4
just finding my feet
Thread Starter
Blitz id3 is the controler,,, can't work out what I do with the oem 2 port boost controller
Do I leave it plugged in and blanked off or disconnect ?
Remember this is japcrap impreza
Do I leave it plugged in and blanked off or disconnect ?
Remember this is japcrap impreza
03-03-2013, 09:46 PM
#6
PassionFord Post Whore!!
Thread
Thread Starter
Forum
Replies
Last Post