2.1 zvh, t3 beige injector.
What pressure please guys.

 

Totally down to the guy who mapped the chip mate.

 

right ok, still got same problem!! Starts running like a dog after 4k. Iv checkd everything but cant find nothing out of the blue, it pulls like a train till 4k, but after that nothing! I seriously need help!

 

Several things could do this. What did the person mapping it say? They should normally be able to tell you strait away what's going on.

 

well thats just it, it was mapped before i bought the car! I have a binder full of reciepts, it just came one day and iv changed everything apart from the fuel pump to solve it, i just dont get it!

 

well thats just it, it was mapped before i bought the car! I have a binder full of reciepts, it just came one day and iv changed everything apart from the fuel pump to solve it, i just dont get it!

 

Strange if you got the engine built and mapped by a reputable builder it should work fine. Especially as you got it already fitted to the vehicle. Have you contacted who made it? If it has not worked since you got it there sounds like there is an inherent problem somewhere along the lines. Who built it?

 

well thats just it, it was mapped before i bought the car! I have a binder full of reciepts, it just came one day and iv changed everything apart from the fuel pump to solve it, i just dont get it!

 

built by APS, but full bottom end re-build by my self. Its happend one day when i was accelorating
into traffic, just started to misfire! Before the bottom end went! Same now, and ive tried everything! When i first got the car it was fucking scary fast! So somethings happend from when i bought it till a few days berofe the big ends went.