On fitting my secs monitor today, im having problems with the map signal, i think i have a dodgy connection on ecu, anyway iv managed to sort that out but now the car wont start, it fires then cuts out, if i disconnect the wire from secs to pin 15 on ecu where its suppose to go the car runs ok.

Iv put the wire straight into the back of the plug could this be where im going wrong as the original wire joins to othersfrom pins 30 ans 11.



John.

 

11 is VREF Neg
30 is VREF Pos
15 is MAP Sensor Signal

Not sure if that helps mate?

 

so why when i connect the secs wire to pin 15 does the car not run??



John.

 

No idea mate, never seen how a SECS monitor is wired up!

Drop Simon a PM/Email/Call im sure he'll help you out when hes back at work on Monday

 

Anyone else had any problems when fitting secs monitor??




John.

 

Sorted now cheers.



John.