MegaSquirt idle valve and coil connector for Zetec Turbo
#1
MegaSquirt idle valve and coil connector for Zetec Turbo
I'm planning of rebuilding my Fiesta RST to a Zetec (blacktop) turbo.
I tried requesting a quote for a MegaSquirt ECU but got this question in return:
It is very difficult for me to check this because atm the car and the engine are stored 50miles away from my home.
Can anyone please tell me how many wires are going to the coil connector on a 2.0 blacktop???
How many wires go to the idle valve, if i reuse the fiesta rst inlet system?
How many wires go to the idle valve, if i use a Zetec 1.8 inlet system?
Do i need an idle valve, lets say if i want to change the one inlet system for another?
I tried requesting a quote for a MegaSquirt ECU but got this question in return:
I'll need to know how many wires are going to the coil connector and how many wires are going to the idle valve.
Can anyone please tell me how many wires are going to the coil connector on a 2.0 blacktop???
How many wires go to the idle valve, if i reuse the fiesta rst inlet system?
How many wires go to the idle valve, if i use a Zetec 1.8 inlet system?
Do i need an idle valve, lets say if i want to change the one inlet system for another?
Thread
Thread Starter
Forum
Replies
Last Post