My mate has just bought a 3dr cossie with the engine out the car etc ive fitted the engine back in today and plumbed it all up etc.

But now the problem there is no spark or power going to the fuel pump at all,does anybody have any idea what the problem could be?

cheers

 

check the ecu is switching the fuel pump relay




steve

 

nice diagram steve,

 

give me a ring going away at 1200 oclock so will call in if rogger will be up and i will have a look

 

I had this on mine ,turned out to be the Immobiliser mucking about.Wouldn,t start all day. Left it for a few hours and it seemed to have sorted itself out.

 

No spark and no fuel pump - CPS?

 

is the loom pluged in to power up the ECU its behind the glove box

 

yeah loom is pluged in to ecu even tried another ecu

 

cps or make sure the dizzy plug and the cps are not mixed

 

You not at Finns and Chrome today mate?

 

has the 3dr got an inertia switch in the boot ?

 

no inertia switch on 3dr

 

Does the fuel pump prime when the ignition is first switched on?

If so and there's no fuel pump on cranking, it does indicate a fault with the crank sensor or wiring. If the crank sensor isn't working, you won't have a spark or fuel pump operation.

 

Also, does this not apply to the ignition amp if no fuel pump or spark?

 

The pump dont even prime mate,im going back over tomorrow to have another look so ill try cps etc

 

just had the same problem with the fuel pump and it was my ignition amp not earthing properly

 

the ignition module needs to be mounted on the heatsink plate with a paste

i know of a melted ecu after 500miles on a new build due to garage mounting it direct on inner wing

 

I got told about this car yesterday of the cleveland rsoc lot.I hope you get it sorted fella.