rose joints
#1
rose joints
i'm sure that's what they are called, but i know you have lots of different ends on the ends of them
here's the dilemma:
this is what i've got
it's for an anti roll bar drop link
how much of the threaded section can i leave to be the "adjustable" bit before it's not enough?
half?
more?
less?
curently it's got half the threads in, but i need to have virtually all of it out to give it the correct length it should be, but there is no way i'm going to do that, but is half the threads in, roughly and inch, enough to make it safe?
here's the dilemma:
this is what i've got
it's for an anti roll bar drop link
how much of the threaded section can i leave to be the "adjustable" bit before it's not enough?
half?
more?
less?
curently it's got half the threads in, but i need to have virtually all of it out to give it the correct length it should be, but there is no way i'm going to do that, but is half the threads in, roughly and inch, enough to make it safe?
Thread
Thread Starter
Forum
Replies
Last Post
SMILER258
Restorations, Rebuilds & Projects.
36
28-09-2015 09:04 AM
Mark V8
Ford Sierra/Sapphire/RS500 Cosworth
4
13-09-2015 09:34 AM